summaryrefslogtreecommitdiff
path: root/trunk/darwin/firmware/Sanguino/GCode_Interpreter.old-version/parameters.h.dist
blob: 5f0f76f01b3422d2fa66c6b87a20d5bb209d9527 (plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
// define the parameters of our machine.
#define X_STEPS_PER_MM   7.976
#define X_STEPS_PER_INCH (X_STEPS_PER_MM*25.4)
#define X_MOTOR_STEPS    400

#define Y_STEPS_PER_MM   11.4855
#define Y_STEPS_PER_INCH (Y_STEPS_PER_MM*25.4)
#define Y_MOTOR_STEPS    400

#define Z_STEPS_PER_MM   320
#define Z_STEPS_PER_INCH (Z_STEPS_PER_MM*25.4)
#define Z_MOTOR_STEPS    400

//our maximum feedrates
#define FAST_XY_FEEDRATE 1600.0
#define FAST_Z_FEEDRATE  50.0

// Units in curve section
#define CURVE_SECTION_INCHES 0.019685
#define CURVE_SECTION_MM 0.5

// Set to one if sensor outputs inverting (ie: 1 means open, 0 means closed)
// RepRap opto endstops are *not* inverting.
#define SENSORS_INVERTING 0

// How many temperature samples to take.  each sample takes about 100 usecs.
#define TEMPERATURE_SAMPLES 3