blob: 53effe9255676da8040c64ce3808b9cb0d1fed4d (
plain)
1
|
This configuration is for a hobby sized (Sherline) servo-operated lathe based on the Pluto servo driver. The hardware is a Pluto FPGA board ($60) which counts the encoders and generates up/down PWM at high frequency in order to drive H bridges for the lathe's servos. On this prototype machine both servos are driven with one L298 dual H bridge (which is usually used to drive one stepper.) This is an example of (very) inexpensive servo use on a hobby machine and it gives very good performance.
|
