# HAL config file for ServoToGo STG ISA board
#
# install driver, this should autodetect the board
# if that doesn't work, try using base=0xABC, where ABC matches your setup
# loadrt hal_stg base=0x200
loadrt hal_stg 

# add functions to servo thread so they will be evaluated
# every servo period
# read inputs first
addf stg.capture-position servo-thread 1
# write outputs last
addf stg.write-dacs servo-thread -1

# connect position feedback signals to encoders
net Xpos-fb <= stg.0.position
net Ypos-fb <= stg.1.position
net Zpos-fb <= stg.2.position

# get feedback scaling from ini file
setp stg.0.position-scale [AXIS_0]INPUT_SCALE 
setp stg.1.position-scale [AXIS_1]INPUT_SCALE 
setp stg.2.position-scale [AXIS_2]INPUT_SCALE 

# connect PID output signals to DACs
net Xoutput => stg.0.dac-value
net Youtput => stg.1.dac-value
net Zoutput => stg.2.dac-value

# set output scaling from ini file 
setp stg.0.dac-gain [AXIS_0]OUTPUT_SCALE
setp stg.1.dac-gain [AXIS_1]OUTPUT_SCALE
setp stg.2.dac-gain [AXIS_2]OUTPUT_SCALE
# set output offset to zero
setp stg.0.dac-offset [AXIS_0]OUTPUT_OFFSET
setp stg.1.dac-offset [AXIS_1]OUTPUT_OFFSET
setp stg.2.dac-offset [AXIS_2]OUTPUT_OFFSET